Not sure if this is the correct cubbhole to put this in, but here goes.
Is anybody else having problems with their 6445G loosing it's IP settings?
I had .17 firmware, and got an update to .18 with no change. At totally random intervals the controller will stop talking on the network. When I go into the controller the IP address is still there, but unless I rewrite the numbers it's deaf as a post... most of the time. I have had a few occasions where even that did not fix the issue and I had to finish the day via the USB cable. I can be working right along, and after three or five or ten jobs, I go to load the next one and I get communications errors.
I do network service, and even my diagnostic equipment could not see the controller until I rewrote the IP address. I have had it misbehave for a few minutes up to a few hours. All of a sudden it will show back up on the network and everything is happy.
6445G IP Address problems
-
Dave Vigness
- Posts: 526
- Joined: Sun Dec 15, 2019
- Location: Kansas City - Rural
- Country: USA
- Nickname: Dave
- Laser Machine Make or Type: Chine Red and Black
- Laser Power: EF RF2 80W
- Laser Bed Size: 20 x 26
- Home Position: TR
- Control Software: RDWORKS
- RDWorks Version: 8.01.54
- Ruida Controller: RDC6445
- Windows Version: 7
- Accessories: Power Switch for air assist / exhaust blower, Ma meter with switch for external digital, dual digital temp gauge, LED lights under gantry and and and.
Pics and a list here. https://drive.google.com/drive/folders/ ... sp=sharing