Installation of Ultimate Air Assist

Symptoms and Cures for the Bodor CO2 Laser
Jerome Telovar
Posts: 9
Joined: Sat Jul 04, 2020 6:36 pm
Location: Paris
Country: France
Laser Machine Make or Type: K40 laser and DIY CO2 in process
Laser Power: 40 and 100W
Laser Bed Size: 840 x 670 mm
Home Position: TR
RDWorks Version: v8.01.48
Ruida Controller: RDC6445
Windows Version: 10 and MAC
Accessories: Z probe, air assist, auto focus

Hi, sorry for the probably silly question but I'm cabling the air assist and still worry about the diode :-)
Could someone tell me if it's ok as on this picture : (orientation of the white bar on the diode and cables?)
The brown wire is connected to +24V, the green on wind, the white on status and the yellow will be the ground for the switch...
Thanks a lot
You do not have the required permissions to view the files attached to this post.
Post Reply

Return to “Bodor - Sponsored by Bodor USA”