Hello There

[Atacan Gucuksahin]

Hi , İ'm New to the forum so that's the place to begin with i assume

Its Ata from Turkey . İ'm using a 130W double headed CO2 laser machine . Happy to meet you all guys . Hopefully we will be learning and helping each other as much as possible .

Best regards.

[Gene Uselman]

Welcome Ata- I have a two head 130w machine as well. Not sure how long you have used it but if you have not saved the Vendor/User files, you should do so now- losing them is common and can be a real hassle. Enjoy- Gene

[Atacan Gucuksahin]

Thank you for your warm welcoming Gene . I have been using it for the last 3 years and don't even know what is vendor/user files so i doubt that if i saved anything about that. (: I mostly use lightburn so i have a user profile saved within the software . Do you mean something like that ? Thanks for your advice by the way.

Have a nice day .

[Pete Cyr]

I believe lightburn save the vendor files automatically.

The Vendor files define the parameters that define the velocity of the laser head, movement correction factors for movement, acceleration values, various timings.

These paramet4rs can be edited by the user but only if the individual understands what they are doing does it work out for the best.
The vendor files can be corrupted or inadvertently over written making the laser a small collection of metal that takes up space but provides no service.

[Atacan Gucuksahin]

Thank you so much for these valuable information . I will check the lightburn software and save the vendor files just in case.

Have a nice day