LaserUser.com Forum (formerly RDWorksLab)

Hi!

I've just checked and V52 is out at RuiDa site

https://780083804obx.scd.wezhan.cn/news ... eId=643416

I'll try it tomorrow.

Enjoy!

As usual, no documentation. And now it won't recognize my web cam. The .49 beta at least recognized the web cam.

wont recognize, you'd think newer would at least see/recognize the camera, even if no documents for setup etc....hmmmm
any obvious new things, features etc?

Thanks! That is all I am looking for. Because after upgraded to V48, all scan got tilt from right to left.

Hello everybody,
I am new here, and i searched for some solution in Google so I found this forum.
I have the following problem:
With my laser I used RDVisionWorks 1.00.86 and everything was fine, except that I didn't succeed to calibrate the laser and camera - in the edges of the table there were an offset like 2-3 cm. I decide to use RDWorksV8 8.01.48-20200418, after that version 8.01.54-20210513...
With both versions I didn't succeed to open the camera and take image from the camera (even it is setup to take picture and import at the start of the app). The softwere "see" the camera and it's model, I will attach some screenshots...
I try and install the softwere also to another computer and the problem is same, obviously it is some setting or install driver or something that should me installed additionally. I even succeed to connect the CorelDraw 12 plugin with RDWorksV8 - with which I was very happy, and only remain to setup the camera to be able to work with the software.
If anyone have an idea what it can be, please help me!
https://photos.app.goo.gl/JGgyKcYVMrQRrFQN6
https://photos.app.goo.gl/te5SYZzTApGxRz8m9
https://photos.app.goo.gl/Z5v8dSYwMJXjvprRA
https://photos.app.goo.gl/HE8jqeuyxgrcgSb16
https://photos.app.goo.gl/juue2bdcrCnqi4KR7
https://photos.app.goo.gl/36X2jNGzgnkTeKmo7

Friends a question

i have RDWorksV8_01_48 version and 644XG controller I tried to install the new RDWorksV8_01_60

but I see he no longer has the 644XG on the list so the 48 is the latest version that i can use?

A lot of us no longer keep up to date [or try to] with Ruida software- Lightburn is more stable and a better program IMHO.

Sorry but Lightburn can talk to 644XG Ruida controller?

Yessir. 6442 and 6445

.59 is that last stable release of RDWorks that I'm aware of. As far as RDWorks, You may still need it to program some of the new registers in the controller firmware. I know that .30 is the latest firmware for the 6445G, and that gets you the job start delay. Some of the other firmware tweaks are still in the works.

I do my design work in Corel, and then pass it through RDWorks via the macro for optimizing and layer order. I tried Light Burn, but I already had Corel and it does so much more, just doesn't have the integrated laser software. It used to be that for a decent camera feature you had to go LightBurn, but the last few revisions of RDWorks aren't bad, and they have a new tweak coming that will allow you to use just a portion of the bed for camera work and a closer camera instead of requiring the whole bed.