LaserUser.com Forum (formerly RDWorksLab)

Got cover back on and now I can start running wires and put all pieces back on that are scattered around my shop.

Installed cover under bed rails to seal air at bottom for exhaust fans.

Slat’s installed.

What is the cover below the blades made of? And where does the exhaust connect- I am confused...

The sheet is plastic with aluminum skin it’s lite weight and is easy to work with. Used by sign companies. There are 2 opening at back for exhaust. I will cover slats with steel sheet with a gap on sides to pull exhaust down to ducts under slats.

I just sold and am still hip deep in a sign shop- that alum composite material [ACM] is great stuff. The paint will burn off but it will work great.

I salvaged a SS electrical panel from discontinued equipment. It’s a little small but will have to do. I think I can shoe horn everything inside. I’ve already had to changed panel controls for second time. I can now mount it and start landing wires.

Finished controls for laser.

Cover is almost done need to put sides on.

Looking very nice.