Cut [or scan] graphic 2 or more times
Posted: Sun Mar 03, 2019
Go to Output tab> Enable feeding> Feeding [number of times to repeat] and Distance- 0
Post by fred ungewitter ยป Fri May 19, 2017 5:18 pm
it's a handy feature, indeed. I was doing multiple passes on glass and needed a pause in order to add soapy water. One can set the distance per speed to get an appropriate pause. I went for 5 seconds by setting 500 mm distance for the 100 mm / second speed.
One could also perform a similar configuration if one had a good solid jig. Pop a work piece into the jig, set a long enough pause, perform the cut (with tabs!) and during the pause, pop the old one out, new one in. A quick hand on the kill switch or pause button might be good if one has a too-short pause, though.
fred