Page 1 of 1
Things are askew
Posted: Fri Mar 08, 2019
by Benjamin Trinkle
So, any speed over 200mm/sec causes this skew. Doesn't matter the power. All other settings staryed the same. In the picture the"why" on the left was at 201mm/sec and the one on the right was at 200. I did multiple speeds and anything above 200 did this. It did this with boxes also.
Anyone have some suggestions?
IMG_20190308_155521686.jpg
IMG_20190308_155511384.jpg
Re: Things are askew
Posted: Fri Mar 08, 2019
by Gene Uselman
Are you using Lightburn software? I have never seen this particular behavior with RDworks,
Re: Things are askew
Posted: Fri Mar 08, 2019
by Benjamin Trinkle
Gene Uselman wrote: Fri Mar 08, 2019
Are you using Lightburn software? I have never seen this particular behavior with RDworks,
Yes I am using lightburn. I might try Rd works on Monday to see if I can replicate it.
Re: Things are askew
Posted: Fri Mar 08, 2019
by Benjamin Trinkle
Edit:. I forgot to mention, it also only does it when bi-directional scanning is off. Works fine when it's on with any speed.
Re: Things are askew
Posted: Sat Mar 09, 2019
by Gene Uselman
Please post your results with RDworks, I am sure that the OZ from LB will be interested too.