LaserUser.com Forum (formerly RDWorksLab)

Hi all.
Chiller went out today and I believe I have it narrowed down to the power supply, which looks like a standard AC Adapter box spliced into the machine. I ordered a new one on Amazon, which I’ll have to cut wires and connect to the power switch and the power side. Voltage and whatnot all match up (I checked with someone much more knowledgeable than myself) and I think I’m on the right track, but still a little iffy as far as electrical work goes.
Has anyone replaced the AC Adapter in their chiller? Where did you order the replacement? Any advice or tips? Thanks in advance!

I have not suffered your fate - yet.

Sorry for the troubles but...some picture of you interior components, the bad pwr supply and anything else that may help the next poor soul with a similar problem would be appreciated.

I’ll post some photos when I get the new supply as well as the results.

Got it fixed. No photos, because it isn’t necessary. Replaced the ac adapter with one with matching specs from Amazon. The one from Amazon came ready to plug into a wall outlet and a power jack on the other end. Cute those off and spliced it in and voila, good to go. Here is the link to the new ac adapter on Amazon. Can’t be positive that it will work universally across all models and manufacturers, so check your specs. Happy lasering!

BINZET AC to DC 24V 3A Power Supply Adapter Converter Regulator, 5.5mm x 2.1mm DC Plug, 24V 3A 72W Wall Plug Switch for DC24V 10M 5050 LED Strip Lights https://www.amazon.com/dp/B00VE6OJM4/re ... JCbBSR7R79