Hello from rural Northern Nevada
Posted: Sat Mar 16, 2019
Hi all,
My Name is Dennis.
I have a fair amount of experience with other lasers (Epilog, and Full Spectrum), but I've gotten my hands on a red and black Chinese-made model.
This one is a 100w beastie (or so I've been told) and has a 900mm by 500mm bed (that's just shy of 36" x24").
The machine came with a Top Wisdom TL-410 controller, and I am in the midst of setting things up and swapping it for a RDC6445G.
I'm looking forward to getting to know RDWorks and Lightburn both and figuring out how to get them play nicely with Illustrator and Photoshop.
I'm just poking around a bit and found this forum from a YouTube video (RD Works Learning Lab 77). Very helpful!
Anyway ... I'll be about.
Cheers!
My Name is Dennis.
I have a fair amount of experience with other lasers (Epilog, and Full Spectrum), but I've gotten my hands on a red and black Chinese-made model.
This one is a 100w beastie (or so I've been told) and has a 900mm by 500mm bed (that's just shy of 36" x24").
The machine came with a Top Wisdom TL-410 controller, and I am in the midst of setting things up and swapping it for a RDC6445G.
I'm looking forward to getting to know RDWorks and Lightburn both and figuring out how to get them play nicely with Illustrator and Photoshop.
I'm just poking around a bit and found this forum from a YouTube video (RD Works Learning Lab 77). Very helpful!
Anyway ... I'll be about.
Cheers!