When I send my project to my laser the speed is wrong and have to adjust in manually.
100W RDC644 system
Speed sent wrong from LB
-
Derrick Lehman
- Posts: 3
- Joined: Mon Apr 08, 2019
- Location: Gillette/Wyoming;
- Country: United States
- Nickname: Derrick
- Laser Machine Make or Type: XM-1060
- Laser Power: 100W
- Laser Bed Size: 60mm X 100mm
- Home Position: TL
- RDWorks Version: V8.01.34
- Windows Version: Win 10
-
Lightburn Admin
- Posts: 58
- Joined: Wed May 31, 2017
- Location: California
- Country: United States
- Nickname: LBAdmin
- Laser Machine Make or Type: Kehui 700x500 (Ruida controller)
- Laser Power: 100w
- Laser Bed Size: 700 x 500mm
- Home Position: TR
- RDWorks Version: 8.0.18
- Windows Version: 10
- Contact:
Can you elaborate on "the speed is wrong"? How do you mean?
One common mistake is setting the software in "Inch" mode, instead of "Inch / mm", if you're used to setting speeds in mm/sec.
One common mistake is setting the software in "Inch" mode, instead of "Inch / mm", if you're used to setting speeds in mm/sec.
-
Derrick Lehman
- Posts: 3
- Joined: Mon Apr 08, 2019
- Location: Gillette/Wyoming;
- Country: United States
- Nickname: Derrick
- Laser Machine Make or Type: XM-1060
- Laser Power: 100W
- Laser Bed Size: 60mm X 100mm
- Home Position: TL
- RDWorks Version: V8.01.34
- Windows Version: Win 10
The cut speed that I set in LB changes when I load the file in the laser and I have to manually change it back to what I had set it to in LB.