Homing after cut
Posted: Fri Apr 19, 2019
When a job ends the head is homing to the bottom-right (normal homing position is upper-left) then returning to the initial job-start position (where I want it).
How can I stop the controller from doing this? I went through all the settings but only the Return Position under Other in User parameters has any noticeable effect (and it's doing what I want it to do -- return to the initial job-start position).
How can I stop the controller from doing this? I went through all the settings but only the Return Position under Other in User parameters has any noticeable effect (and it's doing what I want it to do -- return to the initial job-start position).