LaserUser.com Forum (formerly RDWorksLab)

The go-to online community for laser enthusiasts, professionals, and hobbyists.
https://forum.laseruser.com/

Etched Pub/Beer glass

https://forum.laseruser.com/viewtopic.php?t=3819

Page 1 of 1

Re: Etched Pub/Beer glass

Posted: Mon Apr 22, 2019
by Larry Gonshak
I have the same rotary and made some rings out of dense foam I have. The OD is the same as the OD of the large end of the glass you are engraving.
foam ring2.jpg

Re: Etched Pub/Beer glass

Posted: Mon Apr 22, 2019
by Pete Cyr
hadn't seen you in a while - figured you were getting the hang of it - and looks like you are - Good job and congratulation of starting earn some income!
All times are UTC-05:00
Page 1 of 1

Powered by phpBB® Forum Software © phpBB Limited