Page 1 of 1
New user
Posted: Wed May 01, 2019
by Ollie Treadway
Hi,
I have been using a Rabbit laser at our local makerspace and want to learn more about lasers and how to use them.
Ollie
Re: New user
Posted: Wed May 01, 2019
by Willy Ivy
Welcome Ollie. This is a good place to learn a lot of stuff about lasers. However, as our forum is titled RDWORKS Lab, that is primarily what this forum was created for and we may not be much help with your software. Feel free to do some reading and searching. Once you do and you get the fever, you will probably own one of these lasers with RDWorks software soon.
Re: New user
Posted: Wed May 01, 2019
by Gene Uselman
Willie- Rabbit is also using RDworks software now- they were building both when I toured his shop. Just looked at his site and saw only LaserCut references tho. Gene