LaserUser.com Forum (formerly RDWorksLab)

I had never seen these before [bought from Amazon, but they engraved very well- our engraving looked better than the brand logo. Hard to take a decent picture as everything is shiny.

.

How did your power setting for blasting this compare to an average powder coated tumbler? Less?

Who did you make that mug for Gene?

The mug was made for the young man who bought the business- he is tired of all his relatives grabbing his cups , so he made one for all the people who congregate at the family cottage- there were 'C's and 'Z's depending upon their last names. There were a few that were painted and several plated and we used full safe power and 300 speed and they all looked great.