Hello from Los Angeles, California
Posted: Sat Jul 20, 2019
Hello All,
I have been playing with a FireBallCNC router with a HobbyCNC controller off and on for a couple of years, but last week my son was able to pick up a used yellow Orion Motor Tech 60W laser engraver clone. I think it has a Ruida RDC6442 controller, and I just installed RDWorks v8.01.22, and I need to finish setting up the machine in my garage. I look forward to watching the learning videos, and learning from you all.
I build and fly Radio Control models and look forward to using this cutter as I build some new models.
- Bill Schatz -
I have been playing with a FireBallCNC router with a HobbyCNC controller off and on for a couple of years, but last week my son was able to pick up a used yellow Orion Motor Tech 60W laser engraver clone. I think it has a Ruida RDC6442 controller, and I just installed RDWorks v8.01.22, and I need to finish setting up the machine in my garage. I look forward to watching the learning videos, and learning from you all.
I build and fly Radio Control models and look forward to using this cutter as I build some new models.
- Bill Schatz -