Page 1 of 1
Hello from UK
Posted: Wed Jul 24, 2019
by George Sansom
Hi Everyone
I’ve just purchased my first laser having used cnc for a while.
Looking to gather information on the correct setup of my machine and become accustomed with the laser.
I have a Chinese 7050 machine at 100W.
Regards
George
Re: Hello from UK
Posted: Wed Jul 24, 2019
by Pete Cyr
Welcome George. Ask questions and poke around to see what may interest you here.
Re: Hello from UK
Posted: Wed Jul 24, 2019
by George Sansom
Thanks Pete
At the moment I’m struggling to get the mirrors lined up correctly, I seem to be losing a lot of power through them not being correctly aligned.
Regards
George
Re: Hello from UK
Posted: Wed Jul 24, 2019
by Pete Cyr
George Sansom wrote: Wed Jul 24, 2019
Thanks Pete
At the moment I’m struggling to get the mirrors lined up correctly, I seem to be losing a lot of power through them not being correctly aligned.
Regards
George
viewtopic.php?f=105&t=3480
Re: Hello from UK
Posted: Thu Jul 25, 2019
by Gene Uselman
That is a great topic Pete- I copied it to the FAQ Laser Beam Alignment forum. The K 40 walk thru is great.
Re: Hello from UK
Posted: Thu Jul 25, 2019
by George Sansom
Thank you Pete
That was very useful.