LaserUser.com Forum (formerly RDWorksLab)

Good afternoon from France.
I use RDWorks version 8.00.26 (windows 8.1 enterprise) with the French interface in my computer without printer connexion : I prepare the .rld files before transfering them into a dedicated computer connected to the printer (ARKETYPE Jade L6090).
I regularly receive the following message when I create/modify an object : "L'accès à un fichier non nommé a été refusé" (unnamed file access has been denied). This message (please look at the attached JPG) do not affect the next operations.
I imagine it is a configuration error, but I am unable to find how to suppress these annoying messages...
Any ideas ?
Thanks,
Francois,

If you are trying to open a file created with a newer version of RDWORKs that may be the problem.
RDWORKS files are not backward compatible.

If you created the file then either it is corrupt or something else is wrong...but I am unsure what it may be.

Pete Cyr wrote: Sat Jul 27, 2019 If you are trying to open a file created with a newer version of RDWORKs that may be the problem.
RDWORKS files are not backward compatible.

No the problem occurs when I create/modify an object either in a new (default) project or in an old (saved and re-opened) project.

Francois,

Hello Francois

I've just the same problem as you, very recently due to bad manip with corel
Did you find a solution of your problem ? if so what have you done ?

Thanks a lot,
Gilles