LaserUser.com Forum (formerly RDWorksLab)

Hello all,

Glad to be part of the community. I'm new at lasering but am familiar with CNCing (if that's a word ).

I have a Laguna PL 1220 40 watt that I'm learning to use. I gained a wealth of knowledge already from this site and hope to be in a position to give back in the near future.

Thanks,
Bob

Welcome Bob. The fist step is always the hardest - learning never end with this stuff. Every time I think I have something figured out I find some quirk I have to understand better. Look around -ask questions. Some one will chime in to help.