Hi everyone!
Posted: Mon Sep 23, 2019
Hi everyone!
Happy to be here.
I work at a smaller lab connected to several design- and technology-oriented bachelor's and master's degrees at Aarhus University, Denmark. We have a selection of 3d printers, cnc millers and all the usual suspects of arduinos and raspberry pis and have also recently acquired our own laser cutter. I'm in charge of making the laser cutter play nice with all of our students and since the introduction given to me wasn't the most thorough I have been searching far and wide online for understandable but in depth explanations. That lead me to the RDWorks Learning lab series on youtube which then led me to this forum.
Looking forward to chatting with you all
Nikolaj
Happy to be here.
I work at a smaller lab connected to several design- and technology-oriented bachelor's and master's degrees at Aarhus University, Denmark. We have a selection of 3d printers, cnc millers and all the usual suspects of arduinos and raspberry pis and have also recently acquired our own laser cutter. I'm in charge of making the laser cutter play nice with all of our students and since the introduction given to me wasn't the most thorough I have been searching far and wide online for understandable but in depth explanations. That lead me to the RDWorks Learning lab series on youtube which then led me to this forum.
Looking forward to chatting with you all
Nikolaj