LaserUser.com Forum (formerly RDWorksLab)

Hello,

thanks a lot !! I got it working

What i am struggeling with is how can i move the Laser Head in a spezified Position?

Lets say the Machine Origin is in upper left and i want to move the Laser Head from there exactly to 100x200 as example.

How can i do this in RDWorks ???

I did not found such a window where i can enter any coordinate where i want to move the Laser to.

Matthias

What you are looking for is the Test Tab- home your machine and then you can specify how far to move and which direction.

I split the post as requested and... it did not work as I expected- Gene

Post by Matthias Roschk » Mon Nov 04, 2019 2:02 pm

Hello,

yes, i tried the Offset and also select "Continuos moving". But when i click on Y- for example, the Head moves a bit, but did not move to the entered offset position ?
Did i miss something ?

Matthias
50W China Laser
Top

I assume all your measurements are metric [you being in Europe]? My bed grid is inches and the offset is mm. Also, I assume you have calibrated your axis so that 100mm is actually 100mm on the cut?

Matthias Roschk wrote: Mon Nov 04, 2019 Hello,
thanks a lot !! I got it working :-)
What i am struggeling with is how can i move the Laser Head in a spezified Position?
Lets say the Machine Origin is in upper left and i want to move the Laser Head from there exactly to 100x200 as example.
How can i do this in RDWorks ???
I did not found such a window where i can enter any coordinate where i want to move the Laser to.
Matthias

As luck would have it - Russ just explained this https://www.youtube.com/watch?v=ddecxYBRkrc scroll fwd to 4.49

Ahh cool !!

It explains it...i did it wrong.

Matthias

'Tis in ill wind that blows no one good. Russ' loss is your gain?