andy_spoo
Posted: Sat Dec 21, 2019
After watching a number of Russ's youtube videos I just had to purchase a laser cutter! So it's his fault 
He's already helped me out a few times via email.
If you see quite a few comments on his videos from andy_spoo then that me.
I have a red/black, 60w (have yet to determine actual max wattage) 700 (actually 730) x 600
I've only just purchased it, it's an almost new - bought off ebay one.
I currently have a number of things popping through the post, e.g. stainless steel pins for stand-off, metal plate for bed, temperature monitors etc.
I've already changed the stupidly loud fan for a much quieter, more inline version.
I'm a repair engineer for a well known white good manufacturer, in the UK.
I used to do electronic repairs as a job.
I have 2 cheap 3D printers, a Creality Ender 2 and a ANET A8, both modified (you can't do everything with a Laser Cutter!).
That's me!
He's already helped me out a few times via email.
If you see quite a few comments on his videos from andy_spoo then that me.
I have a red/black, 60w (have yet to determine actual max wattage) 700 (actually 730) x 600
I've only just purchased it, it's an almost new - bought off ebay one.
I currently have a number of things popping through the post, e.g. stainless steel pins for stand-off, metal plate for bed, temperature monitors etc.
I've already changed the stupidly loud fan for a much quieter, more inline version.
I'm a repair engineer for a well known white good manufacturer, in the UK.
I used to do electronic repairs as a job.
I have 2 cheap 3D printers, a Creality Ender 2 and a ANET A8, both modified (you can't do everything with a Laser Cutter!).
That's me!