Hi there!
Posted: Sun Jan 12, 2020
Just joined.
My name is Neil, I come from York (the original one, not the new one
) and I teach woodturning for a living.
I used to work in a school and used a laser most days but it ran on educational only software so I am, in effect, new to this.
Just bought a Chinese 5030 and installed RDworks and found you lot by a link to an improved manual.
Have to say computers are not my strong point and I still haven't sorted how to get the drivers working so no play yet!
My name is Neil, I come from York (the original one, not the new one
) and I teach woodturning for a living.I used to work in a school and used a laser most days but it ran on educational only software so I am, in effect, new to this.
Just bought a Chinese 5030 and installed RDworks and found you lot by a link to an improved manual.
Have to say computers are not my strong point and I still haven't sorted how to get the drivers working so no play yet!