LaserUser Forum

Technical support and discussion for CO₂ laser users, including RDWorks, LightBurn, Ruida controllers, maintenance and troubleshooting.
https://forum.laseruser.com/

Hello from Joe

https://forum.laseruser.com/viewtopic.php?t=4584

Page 1 of 1

Hello from Joe

Posted: Tue Feb 25, 2020
by Joe Adelaars
I am in Corona CA and have access to a CAMfive laser machine. I am very new to this process.

Re: Hello from Joe

Posted: Tue Feb 25, 2020
by Pete Cyr
welcome Joe. You are in good company-most of us are new to this stuff.

Re: Hello from Joe

Posted: Tue Feb 25, 2020
by Joe Adelaars
I have seen RD works software and would like to use it with the CAMfive laser (CFL-CMA 1200) that I have access to. It has a 1st Controller. Will this software work with that machine? We currently have SmartCarve software.
All times are UTC+01:00
Page 1 of 1

Powered by phpBB® Forum Software © phpBB Limited