LaserUser.com Forum (formerly RDWorksLab)

Anyone able to help that may have some knowledge with RF metal tubes? I have one from the ULS-25E that I am working one and I want to use the 6445G I have so I have something that is working so I can continue my PPE production while I wait for the rest of my parts for my Y-1200 build. I have enclosed the diagram for how the RF is supposed to be connected BUT, I have +/- and RCA terminal on my tube. I have searched google and says to make center pin of coaxial "RCA" the PWM and the shield GND but where does enable go? Is that the V adj. wire from the PSU? Then I would need to know the settings for DSP. RF preginition or no-preginition?

-TIA to all that can offer support!!

at least you have to change the "laser mode" from "glass tube" to RF... otherwise, the parameters for frequency will mess everything.

sebastien laforet wrote: Thu Apr 23, 2020 at least you have to change the "laser mode" from "glass tube" to RF... otherwise, the parameters for frequency will mess everything.

This I already know ;P I need to know the rest of the parameters LOL

I am not aware of any others using an RF tube, I searched the forum [and also Lightburn] and only found your topic.