LaserUser.com Forum (formerly RDWorksLab)

I have my machine doing everything properly again. Mostly thanks to posts on this forum. Before when turning on the power to the machine it used to reset itself to the offset home position off the sensors. Now it goes to the sensors then pauses at the offset, then proceeds to the origin position I set from the last job run.
I know I am missing something simple, like a check for remembering origin but cant seem to find where it is to uncheck it.
Thanks in advance for any info

viewtopic.php?f=123&t=4120&p=22986&hili ... ion#p22986

I believe you want current position.....see link above

I will try it. Dont think I have tried with this setting

Earl Andruskievicz wrote: Tue Apr 28, 2020 I will try it. Dont think I have tried with this setting

i re-read your post - -I think you wan the head to be at 0, 0 after it initializes - set it to "Machine Zero"
See attached for more guidance