Page 1 of 1
Inching setting
Posted: Mon May 25, 2020
by Charles Deckert
I can not find where to adjust the "inching" setting. Right now when I push up/down left/right on keypad to move the nozzle the gantry moves the entire breadth or length of the bed. This happened after I had to re-install RDWORKS. My default RDSET file is for a 500/700 bed but the inching setting is elusive. Does anyone know where I can set this to zero or what the actual menu item is to make the adjustment?
Red/Black 100w 500x700
Thanks
Charlie
Re: Inching setting
Posted: Mon May 25, 2020
by Pete Cyr
Re: Inching setting
Posted: Mon May 25, 2020
by Charles Deckert
Thanks for helping, that's not the setting I'm looking for. I am needing to adjust the distance the head travels when pushing the x-y keys on the keypad. The user manual calls it inching but I can not find where to adjust.
Charlie
Re: Inching setting
Posted: Mon May 25, 2020
by Charles Deckert
I found it. On the control board the (manual) setting is where the travel distance is adjusted. Set to 0 to travel as long as the jet is pressed.
Re: Inching setting
Posted: Mon May 25, 2020
by Dave Vigness
The button in the center of the arrows toggles between micro moves one at a time, or move as long as the button is pressed.
Re: Inching setting
Posted: Mon May 25, 2020
by Pete Cyr
Glad you were able to resolve the issue.
Re: Inching setting
Posted: Mon May 25, 2020
by Pete Cyr
Glad you were able to resolve the issue.