LaserUser Forum

Technical support and discussion for CO₂ laser users, including RDWorks, LightBurn, Ruida controllers, maintenance and troubleshooting.
https://forum.laseruser.com/

Engraving Tape Amplifier Faceplate

https://forum.laseruser.com/viewtopic.php?t=4841

Page 1 of 1

Engraving Tape Amplifier Faceplate

Posted: Wed Jun 17, 2020
by Fernando Moreira
Just finish the faceplate for the new version of the "RMD Tape Amplifier" for my friend Ricardo, from RMD Audio Design.

Re: Engraving Tape Amplifier Faceplate

Posted: Wed Jun 17, 2020
by Gene Uselman
Looks very nice- how was the old one done- the pict is kinda small.

Re: Engraving Tape Amplifier Faceplate

Posted: Wed Jun 17, 2020
by Fernando Moreira
The old one was also laser engraved, the difference is that in the new version it is possible to select the attenuation of the vuimeters, and the equalization

Re: Engraving Tape Amplifier Faceplate

Posted: Thu Jun 18, 2020
by Fernando Moreira
Almost Done...
All times are UTC+01:00
Page 1 of 1

Powered by phpBB® Forum Software © phpBB Limited