Hi from PCB
Posted: Sat Jul 11, 2020
Hi,
I'm Jim Mersereau, living in Panama City Beach, FL. I started a couple years ago with a small desktop diode laser, then got into CNC routing with a 36"x36" Open Builds. I started 3D printing last fall with a Ender 3Pro and now finally I have a 20"x28" 60w CO2 laser that I picked up on Ebay. It wasn't the cheapest available but it came well calibrated and I was cutting within 20 minutes of it being delivered.
I have learned a lot over the last few weeks thanks to the YouTube video resources and I am having a blast testing feeds and speeds. I have watched dozens of Russ's videos and am amazed at the level of detail and information that is shared.
Cheers,
Jim
I'm Jim Mersereau, living in Panama City Beach, FL. I started a couple years ago with a small desktop diode laser, then got into CNC routing with a 36"x36" Open Builds. I started 3D printing last fall with a Ender 3Pro and now finally I have a 20"x28" 60w CO2 laser that I picked up on Ebay. It wasn't the cheapest available but it came well calibrated and I was cutting within 20 minutes of it being delivered.
I have learned a lot over the last few weeks thanks to the YouTube video resources and I am having a blast testing feeds and speeds. I have watched dozens of Russ's videos and am amazed at the level of detail and information that is shared.
Cheers,
Jim