LaserUser Forum • Laser not cutting at the same path

Page 1 of 1

Laser not cutting at the same path

Posted: Wed Jul 29, 2020

by Tan Durongphant

When I attempt to cut 2 pass on a project, the second pass is never on the original path. How can I fix this? Is it a belt issue?

Re: Laser not cutting at the same path

Posted: Wed Jul 29, 2020

by Brian Book

Hi Tan .... make sure all the grub screws are tight on the shafts and on the stepper motors.

Brian

Re: Laser not cutting at the same path

Posted: Wed Jul 29, 2020

by Tan Durongphant

Thank you, I'll try that sometime this week.