Page 1 of 1
Convert Honeycomb Bed to Pin Style
Posted: Sat Aug 29, 2020
by Travis Emmel
I wanted to share my design to easily convert a honeycomb style bed into one with very configurable pin supports.
IMG_20200803_134814.jpg
IMG_20200803_134852.jpg
Simply print the attached part and press in a 1/16" x 1" dowel pin (with a little scaling or drilling, a 1.5mm pin should work, as well). Note that the part was created in imperial units so you may need to scale by 2540% in your slicer to arrive at the correct part size.
Re: Convert Honeycomb Bed to Pin Style
Posted: Sat Aug 29, 2020
by Gene Uselman
I like it- are you sure your honeycomb is level, mine was not.
Re: Convert Honeycomb Bed to Pin Style
Posted: Mon Aug 31, 2020
by Travis Emmel
Yeah, I had the same issue. Mine was out by about 2mm L <--> R and 1mm F <--> B. Shimmed up the edges and everything is great!
--Travis
Re: Convert Honeycomb Bed to Pin Style
Posted: Sun Feb 28, 2021
by Marcus Baker
I'm wondering if 1/4" pop rivets stuck in the honeycomb would work?