Hello. Yorkshire man abroad.
Posted: Sun Oct 11, 2020
Hello all.
My name is Steve Carlton. I am a Yorkshire man retired in Washington State.
I mainly used my machines for craft type work, I have done a lot of illuminated acrylic signs for a local games store.
I started with a Jamieson 60 W laser machine but it died recently. I decided to replace it with an OMTech 50W which is the latest version of Russ's Blue machine. I felt confident in purchasing this machine because of all the videos Russ has posted.
A major advantage of the machine was also the fact that it uses Lightburn rather the LaserCut software that ran the Leetro controllers in my old machine.
Using Russ's videos I have greatly improved my engraving and cutting skills and will now embark on modifying this new machine.
My name is Steve Carlton. I am a Yorkshire man retired in Washington State.
I mainly used my machines for craft type work, I have done a lot of illuminated acrylic signs for a local games store.
I started with a Jamieson 60 W laser machine but it died recently. I decided to replace it with an OMTech 50W which is the latest version of Russ's Blue machine. I felt confident in purchasing this machine because of all the videos Russ has posted.
A major advantage of the machine was also the fact that it uses Lightburn rather the LaserCut software that ran the Leetro controllers in my old machine.
Using Russ's videos I have greatly improved my engraving and cutting skills and will now embark on modifying this new machine.