Page 1 of 1
Hello All
Posted: Wed Oct 21, 2020
by Bryan Kelly
Hi, well where to start, I bought a K40 a cpl years ago, after my initial hate for it,,,lmao,but upgrades, tinkering etc.. I grew to love it, and am now getting ready to order a 80 watt 600x400...been looking to order it with a ruida 6445 and it comes with software I will need to learn etc,,,saw a cpl videos from this site and here I am, a newby in sorts...Hope to learn and share with others here...thx
Re: Hello All
Posted: Thu Oct 22, 2020
by Gene Uselman
Welcome Bc- this is a fun thing to be involved in and researching a new machine can be very interesting [and frustrating]. There is a lot of valuable advice here from members who have learned it the hard way, Good luck and have fun. Gene
Re: Hello All
Posted: Fri Oct 23, 2020
by Bryan Kelly
I Thank You for the post, looking forward to being part of this forum,,,not a total newbie, but close, and totally new to this software etc...have a small 40watt for awhile, ordering an 80 watt 6040 very soon once finish hashing out a price...lol...
Re: Hello All
Posted: Tue Oct 27, 2020
by Bryan Kelly
Bryan Kelly wrote: Wed Oct 21, 2020
Hi, well where to start, I bought a K40 a cpl years ago, after my initial hate for it,,,lmao,but upgrades, tinkering etc.. I grew to love it, and am now getting ready to order a 80 watt 600x400...been looking to order it with a ruida 6445 and it comes with software I will need to learn etc,,,saw a cpl videos from this site and here I am, a newby in sorts...Hope to learn and share with others here...thx
well..I did it, change my mind and went abit bigger, just ordered a 900x600 instead of the 600x400...now the wait for ship from China and customs etc...the sweating begins..
Re: Hello All
Posted: Tue Oct 27, 2020
by Gene Uselman
Congrats- always fun breaking in a new machine.