Hello from Italy, Milan
Posted: Thu Oct 29, 2020
Dear All,
I landed here after watching a lot or Russ' YT videos (I'm only a third of the way).
Since we recently bought a 100W 1400x900mm Chinese laser (you know the red and black made by a gazillion companies)... there is a lot to learn and a healthy community is the best option, especially since these machines do not come with any support and do require a better setup than the one they got when shipped!
With a Trocen TL-3120, Lightburn software, a red dot beam combiner and a 4K camera this is overall a good cutting machine for the price point. But we would like to make it even better and the exchange of info with other users is key in doing so.
Looking forward this forum!
Marco
I landed here after watching a lot or Russ' YT videos (I'm only a third of the way).
Since we recently bought a 100W 1400x900mm Chinese laser (you know the red and black made by a gazillion companies)... there is a lot to learn and a healthy community is the best option, especially since these machines do not come with any support and do require a better setup than the one they got when shipped!
With a Trocen TL-3120, Lightburn software, a red dot beam combiner and a 4K camera this is overall a good cutting machine for the price point. But we would like to make it even better and the exchange of info with other users is key in doing so.
Looking forward this forum!
Marco