LaserUser Forum

Technical support and discussion for CO₂ laser users, including RDWorks, LightBurn, Ruida controllers, maintenance and troubleshooting.
https://forum.laseruser.com/

Hi from Scotland

https://forum.laseruser.com/viewtopic.php?t=5174

Page 1 of 1

Hi from Scotland

Posted: Sun Nov 08, 2020
by Garry Mcneil
Hi, Garry here. Just trying to get to grips with my 1490 laser cutter :-)

Re: Hi from Scotland

Posted: Sun Nov 08, 2020
by Gene Uselman
Welcome Garry, I have a similar machine that I am just tuning up to go to it's new owner. If you have not done it already you should record your machine parameters as described in the FAQ section. Gene
All times are UTC+01:00
Page 1 of 1

Powered by phpBB® Forum Software © phpBB Limited