LaserUser.com Forum (formerly RDWorksLab)

Hi Everybody,
Bought this 6040 China co2 Laser from Ali-express about 3 years ago, almost died when I first turn it on, as there was no earth and the plug was upside down..
the description said it would come with DSP controller, which I thought was a Ruida controller, but it turned out to only have the M2 Nano, this actually was very very good and reliable. Finally upgraded to the RDC6445G and installed it last Month, WOowzers that is a job and a half.. it is now running almost perfectly. apart from the X-axis home bounces rapidly and doesn't stop. and I can't get it moving faster then 250mms without it jamming ...
but I have almost solved most of all the issues.
Good night. 2:39am

Welcome Sam- I am guessing you engrave your custom stamps on the laser? It would be a kindness if you would share some info on the process. And ask any questions you may have- we have very helpful members. Gene

Good to see you in here Sam - if you have not already recommend backing up your vendor settings.