LaserUser Forum

Technical support and discussion for CO₂ laser users, including RDWorks, LightBurn, Ruida controllers, maintenance and troubleshooting.
https://forum.laseruser.com/

Centering on Chuck Style Rotary

https://forum.laseruser.com/viewtopic.php?t=5215

Page 1 of 1

Centering on Chuck Style Rotary

Posted: Mon Nov 30, 2020
by Brian Book
Hi everyone .... question .... those of you that use a Chuck Style Rotary, how do you go about finding the Center on your piece ... up till now I have been guessing but would like to be more precise if possible.

Looking forward for your ideas.

Take Care

Brian
All times are UTC+01:00
Page 1 of 1

Powered by phpBB® Forum Software © phpBB Limited