Hello Everyone
Posted: Sat Dec 12, 2020
Greetings. My love for CNC started when I decided to dismantle my Grizzly mill and automate it. Following that I built a small diode based laser and a small plasma table which sat side by side. I always would say that someday I would combine the two into one large machine.
The past few months have been a journey to try and achieve just that. As I face the challenges of poor/no documentation, I have ended up here where I hope to benefit from the advice of some of you who have more experience with this than me.
At the same time, I am glad to help in any way I can. The Ruida control I have (6334M) has literally no documentation, so maybe as I document my findings I can be of help to someone else who may be considering it as a control solution.
The past few months have been a journey to try and achieve just that. As I face the challenges of poor/no documentation, I have ended up here where I hope to benefit from the advice of some of you who have more experience with this than me.
At the same time, I am glad to help in any way I can. The Ruida control I have (6334M) has literally no documentation, so maybe as I document my findings I can be of help to someone else who may be considering it as a control solution.