LaserUser Forum

I know how to do this in RDworks but cannot find a similar adj in LB. Mark and measure a 100mm [for instance] and then calibrate the axis for that distance. Thanks Gene

That function is within the vendor setting of the controller not in RDWORKS

viewtopic.php?f=105&t=3528&hilit=100mm

Yep- I am looking in Machine settings> Vendor settings and Axis XYZ- I see now that there is a calibrate axis down with the Read and Write, Etc buttons. I figured there must be a way to do it as that Oz feller is pretty clever . Thanks Pete