Page 1 of 1
Vendor and User files for RDC 6445 controller?
Posted: Sat Dec 19, 2020
by Gene Uselman
I have a 6445 controller coming Monday to replace this 6344 controller in the new laser- not fond of the touchscreen and have never gotten the 'Wind' function to... function. Would someone please upload a factory Vendor file for this controller- not sure if they are different from the usual 6442 files. Thanks Gene
Re: Vendor and User files for RDC 6445 controller?
Posted: Sat Dec 19, 2020
by Pete Cyr
Re: Vendor and User files for RDC 6445 controller?
Posted: Sun Dec 20, 2020
by Gene Uselman
Thank you, Pete and Dave. This is a great site. Gene
Re: Vendor and User files for RDC 6445 controller?
Posted: Thu Dec 24, 2020
by Dave Vigness
Anybody know if the 644XG and the 6445G use the same vendor file? The only difference is the display, and I want to think that's handled in the HMI not the vendor. Have a guy on another forum that has a 644X and lost all his settings.
Re: Vendor and User files for RDC 6445 controller?
Posted: Sun Dec 27, 2020
by Gene Uselman
I have the 6445 installed and have Lightburn connected [RDworks does not]. Does anyone have a LBset file that they would share? My home is at right rear but I can change that . Thanks Gene
Dave- I don't know if the 6445 and 6442 files are the same- the contollers themselves are slightly different but very similar
Re: Vendor and User files for RDC 6445 controller?
Posted: Sat May 08, 2021
by Gene Uselman
It appears to me that the files for 6442 and 6445 controllers are interchangable.
Re: Vendor and User files for RDC 6445 controller?
Posted: Sat May 08, 2021
by Dave Vigness
Gene,
On;y thing I would caution about, is the single vs. double head versions of the 6442. The 6445 is double head, but only one of the 6442 units is.