LaserUser.com Forum (formerly RDWorksLab)

Hello,

I recently got a 50W 30x50cm Chinese laser cutter fitter with a 1.5" lens and a Trocen AWC708C controller. I'm trying to set it up for rubber engraving and so far I had little success. I was hoping someone from this forum could point me in the right direction. Hopefully I will make a thread on this, in the appropriate section, soon.

Happy holidays.

Regards,
Orestes

Welcome Orestes. Recommend reviewing the FAQ section and backing up your vendor setting if have not already.
See link below discussing manufacture of rubber stamps -should provide insights to engraving rubber even if you are not making stamps.

viewtopic.php?f=112&t=5139&p=27208&hilit=rubber#p27208