Controller Issues

[Clifford Tyree]

My laser was working fine until...... I installed the rotary table and did some work. Then I tried to return to my original configuration and no luck. The X axis appears to respond properly The Y axis is not resetting properly and goes VERY slowly. When I load a file and do a frame the X axis frame works OK but the Y axis is very slow and does not reach the extent of the file.

Any suggestion would be appreciated.

[Pete Cyr]

Did you reset the feed/rotate function when restoring the y axis

[Clifford Tyree]

Thank you for your response. Under "Function" I reset the XY axis, X axis, and Y axis. Nothing changed.

[Clifford Tyree]

Not sure how to reset the feed/rotate function when restoring the y axis but, I will explore.

[Clifford Tyree]

I have restored my X & Y files from my original backup. Now I receive the yellow error message ""Y Slop Over"

Not sure where to go from here.

Any help would be greatly appreciated.

Thanks

[Pete Cyr]

That error message indicates you are too close to the edge of the Y axis boundry and the head does not have sufficient room for the overtravel that will occur for the speed the machine is running.

Move away from the edge 2 or so inches and try again