HELP PLEASE :cry:
Posted: Sat Jan 16, 2021
Hi everyone, I bought a Chinese co2 laser red-black 80W
https://www.aliexpress.com/item/1005001 ... 4c4dXyQGjF
After five minutes of play, I set the machine to default settings. I haven't even cut anything yet. The seller who sold me the machine doesn't want to send me vendor settings.
There would be a good person to help me and send me the vendor settings on my laser? The laser head has its home in the upper left corner.
When I turn on the laser or press reset the head goes to the left corner and in the corner for another 5-10 seconds it tries to go off the X axis. As if there is no limit switch on the left side, but there is a limit switch on the right side. The only problem is the X axis, the Y axis seems to be fine. The seller only told me to change these settings: X axis ： Breadth : 700mm Step length : 9.02330 Y axis : Breadth : 500mm Step length : 4.20000
Thanks for help Michal
https://www.aliexpress.com/item/1005001 ... 4c4dXyQGjF
After five minutes of play, I set the machine to default settings. I haven't even cut anything yet. The seller who sold me the machine doesn't want to send me vendor settings.
There would be a good person to help me and send me the vendor settings on my laser? The laser head has its home in the upper left corner.
When I turn on the laser or press reset the head goes to the left corner and in the corner for another 5-10 seconds it tries to go off the X axis. As if there is no limit switch on the left side, but there is a limit switch on the right side. The only problem is the X axis, the Y axis seems to be fine. The seller only told me to change these settings: X axis ： Breadth : 700mm Step length : 9.02330 Y axis : Breadth : 500mm Step length : 4.20000
Thanks for help Michal