LaserUser.com Forum (formerly RDWorksLab)

Hi everyone,

I'm, let's call it "responsible", for the laser cutter in our maker space. Meaning I get to fix, what others break
We've had this laser for about 4 months now and are just getting it up and running for our members. Before that, we had a Lotus Lasermaxx 125 (which is basically a chinese cutter reworked to conform to european standards).

We also built our own fume extractor with filters and use an authorisation system using rfid.

Anyway, that's all I can think of for an introduction. Anything else would be TMI

Thanks for reading.

Welcome Thomas. Recommend backing up your vendor settings...and good luck keeping up with your restoration efforts after other use the equipment

Thank you very much. And a backup was the first thing I did