LaserUser.com Forum (formerly RDWorksLab)

I was using Lightburn on my OMT 50W laser and everything was going well! The hard drive crashed along with all the data that was on it. So that is gone. I have another computer so I was trying to setup LightBurn on there. When I open LB the device setup finds the Ruida driver but I get this "Ruida 644xg DSP" under that it says "You have chosen a DSP device, But you do not have a DSP license" . When I go to create Manually “Ruida” doesn’t show up on the list of drivers. Remembering that I am a newbie can you please help me Lightburn to work again?
Thank you
Chuck

You need to contact Lightburn... They will straighten it out for you.

Thank you!! I wish they were prompt to respond as you were!!! Thanks
Chuck

We usually are, but so far I don't see anything from a 'Chuck Smith' in our support emails.