Page 1 of 1
Hello
Posted: Wed Mar 10, 2021
by Wiktor Prokop
Hello everyone, i'm from poland. I have an 80W 50x70 machine.
I have some problems with the machine, so I wanted to join a well-known group of people.
Greetings
Re: Hello
Posted: Wed Mar 10, 2021
by Pete Cyr
WelcomeWictor. Recommend you back up your vendor settings.
Re: Hello
Posted: Wed Mar 10, 2021
by John Stevens
Hi
I'm John and been following Russ. Lots of good stuff on his channel
I have a Tenhigh laser, I bought about 2 yrs ago but wish I had chosen something better knowing what I know now. Have just replaced the controller with a mini Gerbil (was using nano m2 and k4o whisper software).
Laser make: Ten high 60w 400x300
Controller: Mini Gerbil
Software: Lightburn
Re: Hello
Posted: Thu Mar 11, 2021
by Pete Cyr
Welcome John. Recommend you back up your vendor settings.