Hi, rebuilt a scrapped gcc x252
Posted: Sat Apr 03, 2021
Hi from the Netherlands.
Bought a few months ago a scrapped GCC X252 Lasserpro machine. Since many parts were gone i rebuilt it with a Ruida RDC6445g controller, for x and y axes closed loop nema 17. Used the left z motor with a new stepper. The mirrorholders were still there but the mirror were missing. As was the lensplate. Made them of aluminium on my lathe and must admit that they work fantastic. In the meanwhile i am still in a steep learning curve and hope to find and share knowledge here.
Eduard
Bought a few months ago a scrapped GCC X252 Lasserpro machine. Since many parts were gone i rebuilt it with a Ruida RDC6445g controller, for x and y axes closed loop nema 17. Used the left z motor with a new stepper. The mirrorholders were still there but the mirror were missing. As was the lensplate. Made them of aluminium on my lathe and must admit that they work fantastic. In the meanwhile i am still in a steep learning curve and hope to find and share knowledge here.
Eduard