LaserUser.com Forum (formerly RDWorksLab)

Hi everyone,

I'm completely new to lasers, I chose to build my own after researching the Glowforge and decided I wanted a better laser. I'm partway through building Rob's Further Fabrication Y1200 build. This will be an 80W CO2 laser with a 24" x 48" bed. Looking forward to learning from you all!

Welcome Cory - you are learning from the ground up all about your laser. Be sure to backup your vendor settings.

I am guessing you have found our DIY builders section by now- we have several members in process of building machines based on that plan.