LaserUser.com Forum (formerly RDWorksLab)

Hi. Im from Serbia. I recently bought 6445G laser cuter. And here i hope to find some answers to problems i encounter on this laser jorney.

Welcome Marija. Recommend you backup your Vendor settings.

This is a good advice but came too late i have some issues now with bitmaps importing from corel and changing positions on the drawings when transfered from corel. It must be some setting but I cant seem to find it.

Yes - but fear not, that is not an issue with your settings - it is just an poor function of RDWORKS -nothing is broken with your setup.
The import just stinks.

I would recommend LightBurn as a much better software- there is a free trial.