Page 1 of 1
New to Co2 in the UK
Posted: Tue Jun 15, 2021
by Matthew Ullman
Hi everyone, Thanks for accepting me
My name is Matthew im in Suffolk in the UK and have purchased my first Co2 laser,
https://www.ebay.co.uk/itm/293919595820
Its going to be a learning curve but with Russ's videos, youtube and hopefully this forum i should be running well in no time, to then pass on my knowledge to others in this position.
thanks again
Matthew
Re: New to Co2 in the UK
Posted: Tue Jun 15, 2021
by Pete Cyr
Welcome Mathew - be sure to back up your vendor settings. They are easily lost and difficult to recover.
Re: New to Co2 in the UK
Posted: Tue Jun 15, 2021
by Matthew Ullman
ooo thank you, will i find instruction in the manual or somewhere on here? i have the KT332N controller in it.
Re: New to Co2 in the UK
Posted: Tue Jun 15, 2021
by Matthew Ullman
oh just found russ's video about doing it, will my passwords be the same do you know?
Re: New to Co2 in the UK
Posted: Tue Jun 15, 2021
by Pete Cyr
Not sure -
RD8888 / rd8888
HF8888 / hf8888
CC8888 / cc8888
Re: New to Co2 in the UK
Posted: Thu Dec 23, 2021
by Bernd Uthoff
Matthew Ullman wrote: Tue Jun 15, 2021
oh just found russ's video about doing it, will my passwords be the same do you know?
It's a little late but might help others, the password for my KT332N is
RX6666
Re: New to Co2 in the UK
Posted: Thu Dec 23, 2021
by Gene Uselman
KT332N is apparently built by Ruida [which most of us use]- if you would keep us up to date with your experiences with this controller we will make note of it in our FAQ section for future users. Gene