Page 1 of 1
Simulation problem
Posted: Fri Jun 18, 2021
by Marko Stojanov
Rdworks was working fine, suddenly he was crashing everytime i click on Star button. I reinstalled sowftware and now is working fine, but simulation button is problem... When i for example want to cut 10 different object and i run simulation laser head between object is going extremely slow, even when I increase speed. Does someone have same problem and does anybody knows solution for this?
Re: Simulation problem
Posted: Fri Jun 18, 2021
by Jeffrey Aley
Marko Stojanov wrote: Fri Jun 18, 2021
Rdworks was working fine, suddenly he was crashing everytime i click on Star button. I reinstalled sowftware and now is working fine, but simulation button is problem... When i for example want to cut 10 different object and i run simulation laser head between object is going extremely slow, even when I increase speed. Does someone have same problem and does anybody knows solution for this?
There is a setting for the speed when the laser is moving but not cutting. Perhaps that somehow is set to a low value. Look for the User tab in the upper-right, then look for "Idle Speed". Mine is set to 70mm/s.
I hope this helps,
-Jeff
Re: Simulation problem
Posted: Sat Jun 19, 2021
by Marko Stojanov
Yeah, mine is 25. Do you know how to change that value?
Re: Simulation problem
Posted: Sat Jun 19, 2021
by Gene Uselman
I do not use RDworks anymore but I think I remember at the bottom of the screen you must first ' Read' the file and then after you make your changes, you must 'Write' to save in the controller memory.
Re: Simulation problem
Posted: Sun Jun 20, 2021
by Marko Stojanov
Thank you!